Hydrocoll T is a clear solvent based temporary protective
coating for use on glass fittings in paint spraybooths to
collect paint overspray and facilitate easy maintenance. After
application, it dries to a tough film. Does not reduce the
transmission of light by any practicalextent. Easily peelable
when necessary. Hydrocoll T can also be used as a general
purpose protectivecoating on ferrous metals and aluminium.
Method of use
Use as supplied. Do not thin prior to use.
Coverage max. 2 m²/ltr.
Touch dry after 10-15 minutes, peelable after 1-2 hours.
Apply by spray using either gravity or pressure feed methods.
Apply 1 double pass wet-in-wet, thick enough to give a film
of ± 0,08 mm after drying, to achieve easypeelability
from all smooth metal and glass surfaces.
Do not apply to painted or plastic surfaces orother solvent-sensitive
surfaces like rubber etc. Application with normal spraying
Equipment
Nozzle 2,0 mm with special
needle and cap
Air pressure 1,5 bar
Pot pressure 3 to 4 bar
Simply peel from the surface when the coating is contaminated
and light visibility is becoming impaired.
Badly contaminated areas can be cut around with a sharp knife,
removed, and touched in again.
Remove the coating by running a sharp knife or scraper around
the seams of the panel and peel fromthe top in a continuous
sheet
. The surface must be carefully patch tested on ±
0,5-1 m² before use to ensure no surface attack occursand
the product remains easily peelable after normal usage conditions.
